The Drybee dry bilge system is designed to remove even the smallest remaining puddles of water from your boat’s bilge, ensuring it stays completely dry.

The suction pad is 3d printed using PETG. It has a cross slot to allow water flow distribution. Make the suction pad to work more efficiently .

The suction pad can fit mid-V and deep-V boats with a deadrise between 17–30 degrees, and it can also be used on flat-bottom boats.

The water detection sensor monitors rising water levels and engages the pump immediately, helping keep the bilge as dry as possible. You can mount the water detection sensor seperately on a higher location or embed it in the suction pad. You can also set up the timer to run the pump at fixed intervals. The sensor can be completely disabled by putting it away.

The kit contains the full package, including the pump body, suction pad, foam, water filter, water sensor, 3 meters pipe, and wiring harness.

Specifications:
Power supply: 12v
Idle power consumption : 0.05w
In action power consumption: 5w
Flow rate: 1L/min
Pump Box dimension: 19.5cmx9.5cmx6.5cm
Suction pad dimension: 14.5cmx7.5cmx1.5cm
Pipe included: 3m
Sensor cable length: 1.5m
Power cable length: 1.5m

Home

Keep Your Boat Bilge Dry Automatically

Drybee dry bilge pump system: Keep your bilge bone-dry and odor free